Mandriva Linux

Installation Instructions

Available:

(contributors welcome!)


Required configuration

Installing Mandriva Linux is, in most cases, as simple as putting your Installation CD in your CDROM drive, and restarting your machine. Please refer to point 1.

NOTE:


Below are listed the different ways to install Mandriva Linux:

  1. Boot directly from CD
  2. Make a boot floppy with Windows
  3. Other install methods


1. Boot directly from CD

The Installation CDROM is bootable. In most cases, just insert the CD into the drive and reboot the machine. Follow the instructions displayed on screen: press the [Enter] key to start the installation, or press [F1] for additional help.

NOTE:

On some laptops (portable computers), the system may not be able to boot from the CD. In such a case, you should prepare a boot floppy. See point 2 for details.

[top of this page]


2. Make a boot floppy with Windows

If your computer cannot boot from the CDROM, you must make a boot floppy under Windows as follows:

To begin the installation:

[top of this page]


3. Other installation methods

If for any reason the previous methods do not fit your needs (you want to perform a network install, an install from pcmcia devices or ...), you will also need to make a boot floppy:

Here the list of boot images:

cdrom.img install from CD-ROM
hd_grub.img install from hard-disk (from a Linux, Windows, or ReiserFS filesystem)
you can configure it for your system at: http://qa.mandriva.com/hd_grub.cgi
network.img install from ftp/nfs/http
NOTE: you will need to insert network_drivers.img in your floppy drive when prompted
pcmcia.img install from pcmcia devices (warning, most pcmcia network adapters are now directly supported from network.img)

You may also burn boot.iso on a CDROM and boot from it. It supports all installations methods, cdrom, network, and hard-disk.

[top of this page]


You can also use a text mode installation if, for any reason, you have trouble with the default graphical installation. To use it, press [F1] at Mandriva Linux welcome screen, then type text at the prompt.

If you need to rescue your existing Mandriva Linux system, insert your Installation CDROM (or any relevant boot floppy), press [F1] at Mandriva Linux welcome screen, then type rescue at the prompt.

See http://www.mandrivalinux.com/drakx/README for more technical information.

[top of this page]


Below are the main stages of installation:

  1. Insert your Installation CDROM (or Installation Floppy disk if necessary) and restart your machine.
  2. Press [Enter] when the Mandriva Linux welcome screen appears and carefully follow the instructions.
  3. When the installation is complete take out the CD-ROM when ejected (and any floppy disk if present in drive); your machine will restart. If it does not, restart it manually.
  4. Mandriva Linux will start. After bootup, you can login on your machine under the user account setup during install, or as "root".

Important note:

The "root" account will give you unrestricted access to your Linux system. Do not use it except to configure or administer Linux. For every day use, use a normal user account which you can configure with the "userdrake" tool, or with the commands "adduser" and "passwd".

Good luck with Mandriva Linux !

[top of this page]


For additional support, see the following: