[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [bluetooth] FH Selector implementaion query...
Hi all,
I am facing some problem on FH selector.
1.Are Y1 and Y2 1-bit input??If yes,how come the CLK1 * 32 (this might need 6-bit
input)?
2. Does the Y1 input need to be appended to 5-bit before xor with input C??
Example: if Clk1=1,
then Y1 = "11111" xor C
3. What about the case for Y2,
example: if Clk1 =1
then Y2 = "100000"
Adder2 = E[6:0] + F[6:0] + PERM5_out[4:0] + 6'100000
Is the Y2 input for the Adder2 correct???
Hope someone can help me.
Best Regards
----- Original Message -----
From: ccsin@k...
To: bluetooth@o...
Date: Tue, 6 May 2003 06:41:55 -0100
Subject: [bluetooth] FH Selector implementaion query...
>
>
> Hi Jamil,Anilnainwal,
>
> I got few queries on FH selector implementation,refer to the
> "Bluetooth IP core spec"
> on section 2.10.
>
> 1. What is the purpose of the "Valid" port??
>
> 2. I suggest to add a "Train" input-port for this block.if train =
> 1, offset =24 is
> used,however if train = 0,offset = 8 is used.Without this "train"
> port,it's hard to
> determine what is the offset value to be used and for how long that
> according to the
> Ninquiry and Npage(since we do not know these Ninq/Npage in this
> block).Is my
> concept ok??correct me if i'm wrong,since I'm currently
> implementing this block.
>
> 3.Another input-port might be needed,which is "Reset",this reset
> can be used to reset
> some "Registers" in this block,like "Nreg",which is a counter in
> Page and Inquiry
> Response.
>
>
> Hope to get Feedback from you ASAP.
>
> Best Regards,
>
> Chuan Chew
>
--
To unsubscribe from bluetooth mailing list please visit http://www.opencores.org/mailinglists.shtml