Next: Comparison in Dired, Previous: Shell Commands in Dired, Up: Dired
This section describes Dired commands which alter file names in a systematic way.
Like the basic Dired file-manipulation commands (see Operating on Files), the commands described here operate either on the next n files, or on all files marked with `*', or on the current file. (To mark files, use the commands described in Marks vs Flags.)
All of the commands described in this section work interactively: they ask you to confirm the operation for each candidate file. Thus, you can select more files than you actually need to operate on (e.g., with a regexp that matches many files), and then refine the selection by typing y or n when the command prompts for confirmation.
dired-upcase). If the old file names are Foo
and bar, the new names are FOO and BAR.
dired-downcase). If the old file names are Foo and
bar, the new names are foo and bar.
The four regular-expression substitution commands effectively perform a search-and-replace on the selected file names in the Dired buffer. They read two arguments: a regular expression from, and a substitution pattern to.
The commands match each “old” file name against the regular
expression from, and then replace the matching part with to.
You can use `\&' and `\digit' in to to refer to
all or part of what the pattern matched in the old file name, as in
replace-regexp (see Regexp Replace). If the regular expression
matches more than once in a file name, only the first match is replaced.
For example, % R ^.*$ <RET> x-\& <RET> renames each selected file by prepending `x-' to its name. The inverse of this, removing `x-' from the front of each file name, is also possible: one method is % R ^x-\(.*\)$ <RET> \1 <RET>; another is % R ^x- <RET> <RET>. (Use `^' and `$' to anchor matches that should span the whole filename.)
Normally, the replacement process does not consider the files' directory names; it operates on the file name within the directory. If you specify a numeric argument of zero, then replacement affects the entire absolute file name including directory name. (Non-zero argument specifies the number of files to operate on.)
Often you will want to select the set of files to operate on using the same regexp that you will use to operate on them. To do this, mark those files with % m regexp <RET>, then use the same regular expression in the command to operate on the files. To make this easier, the % commands to operate on files use the last regular expression specified in any % command as a default.