mu SETUP - Mulinux as Gateway

From: Sven Conrad (
Date: Thu Apr 06 2000 - 10:58:47 CEST

> Does anyone use Mulinux as Gateway and can tell me how two configure
> multiple ethernet cards?

Please.... tell us about your networks. This can't be answersed in

> I have two ne2000 clones and later i will have one ne2000 and one 3Com

This only has effect to module loading. After successfull load you have
eth0, eth1.

> What i tried:
> use setup -f eth and choosed ne as module and put io=240,300 irq=3,10 as
> parameters.
> the two cards were detected but i could not configure the second card
> ifconfig and route cause the device eth1 was not found.
What does this mean? If both card are detected eth0 and eth1 should be
there. What are the message when loading module ne and what is "cat
/proc/net/dev" look like?


Sent through GMX FreeMail -
To unsubscribe, e-mail:
For additional commands, e-mail:

This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:13 CET